A 24-26mm hole is drilled into the front of the furniture according to the dimensional sketch. The lock body is then loosely screwed to the inside of the flap/drawer with 2 screws. The stop is mounted loosely on the inside of the furniture accordingly.
The position can now be adjusted using the elongated holes. The clasp must be positioned so that the bolt engages properly, but not too deep, which makes opening difficult. The closure is then fixed with 2 additional screws.
The stop is now also adjusted accordingly until the flap closes cleanly and then finally screwed tight.
It is extremely easy and intuitive to use. You put your finger through the hole in the front and press the button into the clasp. The trap is then drawn in automatically. Now you can open the flap on the exposed grip edge in the closure.
To close, it is sufficient to press the flap shut. The lock does not have to be operated. The latch runs over the slope of the stop and then snaps back into place using spring force. The flap is then automatically locked again.
Weight set with screws 12mm: 44g
The stainless steel mounting screws 12mm are suitable for 10mm to 12mm panel thickness. In the set without panels, a 25mm hole in the furniture front is sufficient. We recommend testing the usability on a sample board.